Husqvarna EZ24T/ 966659601 Instrukcja Użytkownika

EZ4824 / 966612901EZ4824 CA / 966659501EZ24T / 966659601Operator ManualPlease read the operator’s manual carefully and make sure you understand the in

SAFETY108011-520Never take passengersWARNING!Engine exhaust and certain vehicle components contain or emit chemicals considered to cause cancer, birth

SAFETY118011-670aPersonal protective equipment6003-004Mow up and down, not side to sideWARNING!When using the machine, approved personal protective eq

SAFETY128011-519Be extra cautious when driving on slopes8011-517Never allow children to operate the machine8011-518Keep children away from work area•

SAFETY138011-516Never fill the fuel tank indoorsWARNING!The engine must not be started when the driver’s floor plate or any protective plate for the mow

SAFETY148011-515Never drive the machine in an enclosed spaceWARNING!The battery contains lead and lead compounds, chemicals that are considered to cau

SAFETY15Sparking can occur when working with the battery and the heavy cables of the starter circuit. This can cause battery explosion, fire or eye inj

SAFETY16IMPORTANT INFORMATIONThe parking brake is not sufficient to lock the machine in place during transport. Ensure that the machine is well fastene

CONTROLS17This operator’s manual describes the Husqvarna Zero Turn Rider. The rider is fitted with Briggs & Stratton four-stroke overhead valve eng

CONTROLS188058-022Steering controlsSteering Control LeversThe machine’s speed and direction are continuously variable using the two steering controls.

CONTROLS19Parking Brake8058-020Parking brake releasedIMPORTANT INFORMATIONThe machine must stand absolutely still when applying the parking brake. Alw

©2011 All rights reserved.Orangeburg, SC. Printed in U.S.A.In order to implement improvements, specifications and designs can be altered without prior

CONTROLS208052-001Choke controlIgnition SwitchThe ignition switch is placed on the control panel and is used to start and stop the engine.FusesFuses a

CONTROLS21Fuel TankRead the safety instructions before refueling. The machine has one fuel tank, just behind the seat. The tank capacity is 3.5 gallon

CONTROLS22Fuel Shut Off ValveThe fuel shut off valve is located at the left rear of the seat. The valve is off when the handle tab is turned perpendic

CONTROLS23Hour MeterThe hour meter displays the total operating time.It will flash CHG OIL (Change Oil) at 50 hour intervals. The flash duration is one

OPERATION24Read the Safety section and following pages, if you are unfamiliar with the machine.TrainingDue to unique steering capabilities, zero turn

OPERATION258058-019Set mower deck to transport position8058-020Pull parking brake upwards to activate.8052-017Depress blade switchBefore Starting1. R

OPERATION268052-001Set the throttle8052-001Set the choke control8061-026Place controls in neutral position5. Move the steering controls outward to th

OPERATION27IMPORTANT INFORMATIONDo not run the starter for more than 5 seconds each time. If the engine does not start, wait approximately 10 seconds

OPERATION288011-642Jumper cable connectionIMPORTANT INFORMATIONYour mower is equipped with a 12-volt negative grounded system. The other vehicle must

OPERATION298058-019Mower deck lifting leverWARNING!Make sure that no one is near mower when engaging blade switch.Make sure the work area is free from

CONTENTSINTRODUCTION ...5Driving and Transport on Public Roads ...5Towing ...

OPERATION305. Move throttle control to full throttle.6. Engage the mower deck by pulling out the blade switch.The machine’s speed and direction are

OPERATION31Mowing Tips• Observe and flag rocks and other fixed objects to avoid collisions.• Begin with a high cutting height and reduce it until the

OPERATION32Stopping the EngineAllow the engine to idle a minute in order to attain normal operating temperature before stopping it, if it has been wor

OPERATION33Moving Machine by HandZT-2800 Bypass LinkagesWhen pushing or pulling the mower, engage the ZT-2800 bypass linkages. The ZT-2800 hydro relea

MAINTENANCE34Maintenance ScheduleThe following is a list of maintenance procedures that must be performed on the machine. For those points not describ

MAINTENANCE35WARNING!Before performing any service or adjustment checklist• Engage the parking brake.• Place the Blade-switch in the disengaged posi

MAINTENANCE36BatteryThe mower is equipped with a maintenance free battery and does not need servicing. However, periodic charging of the battery with

MAINTENANCE37Safety SystemThe machine is equipped with a safety system that prevents starting or driving under the following conditions.The engine can

MAINTENANCE38V-beltsCheck every 100 hours of operation. Check for severe cracking and large nicks.NOTE: The belt will show some small cracks in normal

MAINTENANCE3913524Pump BeltReplacing pump beltPark the mower on a level surface. Engage the parking brake.8058-1861. Spring loaded idler2. Fixed idl

WARNING!Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause c

MAINTENANCE40132Blade replacement1. Remove blade bolt by turning counterclockwise.2. Install new or resharpened blade with stamped GRASS SIDE facing

MAINTENANCE4112Adjusting the Mower DeckLeveling deckAdjust the deck while the mower is on a level surface. Make sure the tires are inflated to the corr

MAINTENANCE4212Anti-Scalp RollersAnti-scalp rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desire

MAINTENANCE43IMPORTANT INFORMATIONUse protective glasses when cleaning and washing.CleaningRegular cleaning, especially under the mower deck, will inc

LUBRICATION44GeneralRemove the ignition key to prevent unintentional movements during lubrication.When lubricating with an oil can, it must be filled w

LUBRICATION45Front Wheel MountLubricate with a grease gun, one zerk for each wheel mount, until the grease is forced out.Use only good quality bearing

LUBRICATION46321212Transaxle (Transmission) Fluid ChangeThis transaxle is designed with an external filter for ease of maintenance. To ensure constant

TROUBLESHOOTING47Problem CauseEngine will not start • Blade switch is engaged.• Steering controls are not locked in the neutral position• Parking b

TROUBLESHOOTING48Problem CauseEngine overheats • Clogged air intake or cooling fins• Engine overloaded• Poor ventilation around engine• Defective e

49STORAGE49Winter StorageThe machine should be readied for storage at the end of the mowing season or if it will not be in use for longer than 30 days

INTRODUCTION5CongratulationsThank you for purchasing a Husqvarna ride-on mower. This machine is built for superior efficiency to rapidly mow primarily

SCHEMATICS50

TECHNICAL DATA51Engine crankshaft bolt 50 ft/lb (67 Nm)Deck pulley bolts 150 ft/lb (203 Nm)Lug nuts 75 ft/lb (100 Nm)Blade bolt 90 ft/lb (122

TECHNICAL DATA52EZ4824 / 966612901EZ4824CA / 966659501EZ24T \ 966659601EngineManufacturer Briggs & Stratton Briggs & StrattonType Endurance En

TECHNICAL DATA53EZ4824 / 966612901EZ4824CA / 966659501EZ24T \ 966659601FrameCutting Width 48" / 122cm —Cutting Height 1½ - 4" / 3.8 - 10.2 c

54CONFORMITY CERTIFICATESUSA requirementsLabels are placed on the engine and/or in the engine compartment stating that the machine will fulfill the req

55SERVICE JOURNALAction Date, mtr reading, stamp, signDelivery ServiceCharge the battery.qAdjust the tire pressure of all wheels to 15 PSI (1 bar).qMo

56SERVICE JOURNALAction Date, mtr reading, stamp, sign25-Hour ServiceCheck the engine air filter.qSharpen/Replace mower blades if required.qCheck the t

57SERVICE JOURNALAction Date, mtr reading, stamp, sign100-Hour ServicePerform the 25-hour service.qPerform the 50-hour service.qChange the engine oil

58SERVICE JOURNALAction Date, mtr reading, stamp, signAt Least Once Each YearClean the engine’s cooling air intake (25 hours).qReplace the air cleaner

INTRODUCTION6Good ServiceHusqvarna’s products are sold all over the world and only in specialized retail stores with complete service. This ensures th

www.husqvarna.com115 384627 RevC2011-10-06

SYMBOLS AND DECALS7N Reverse Neutral Fast Slow Choke Fuel Warning! Parking Brake CE conformity Warning! Rotating blades, Do not touch part

SYMBOLS AND DECALS8 Read Shut off engine and Keep a safe Use on slopes No passengers Operator’s remove key before distance from no greater

SAFETY9General Operation• Read, understand, and follow all instructions on the machine and in the manual before starting.• It is recommended that so